TM-9-2320-283-34-2
TRUCK TRACTOR, LINE HAUL, 50,000 GVWR, 6X4, MQ15A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 1983
TM-9-2320-283-34-2 - Page 134 of 570
TM 9-2320-283-34-2
REAR TANDEM AXLES.
3-74. REAR-REAR AXLE FLANGE AND OIL SEAL REPLACEMENT (Continued).
LOCATION/ITEM
ACTION
REMARKS
1. Nut (5).
Remove from item (6).
Use suitable yoke tool
to prevent item (6) from
turning.
2. Input flange assem- Remove from item (6).
bly (3) and washer
(4).
3. Oil seal (2).
Remove from item (1).
Tap the backside of item
(3) for ease of removal.
Use a hammer and chisel
for ease of removal.
Discard item (2).
4. All parts.
Clean.
Refer to paragraph 3-4.
5. All parts.
Inspect.
Refer to paragraph 3-5.
6. New seal (2).
Install into item (1).
Coat outside edges of
item (2) with OE/HDO 10
for ease of installa-
tion.
7. Input flange assem-
Install and torque item (5)
Coat outside oil seal
bly (3), washer
to 560-600 lb-ft.
(4), and nut (5).
surface of item (3) with
OE/HDO-10 to prevent
damage to item (2). Use
suitable yoke holding
tool to prevent item (6)
from turning.
NOTE
Follow-on maintenance action required:
Connect drive shaft (TM 9-2320-
283-20).
3-690
Back to Top
