TM-9-2320-342-10-1
TRUCK, WRECKER, 8X8 M984A4
TECHNICAL MANUAL; OPERATOR'S MANUAL
OCTOBER 2008
TM-9-2320-342-10-1 - Page 1045 of 1428
OPERATOR MAINTENANCE
TOW HEMTT - REAR LIFT
INITIAL SETUP:
Not Applicable
HOOKUP
NOTE
•
This procedure is a two soldier task.
•
The following rear lift procedures apply to all models HEMTT series
vehicle EXCEPT M984A wrecker. If performing a rear-lift procedure
to another HEMTT M984A wrecker, refer to Tow HEMTT M984 - Rear
Lift. (WP 0063)
1.
Review procedures for operating retrieval towing system (WP 0058) and prepare
retrieval system for operation. (WP 0059)
WARNING
•
Hold cross tube when removing springs, cross tube can swing in all
directions and adapters may slide off. Failure to comply may result in
injury or death to personnel.
•
Intervehicular air lines are not connected when towing from rear.
Disabled vehicle will not have braking. Use extreme care when
transporting disabled vehicle using rear hookup. Failure to comply
may result in injury or death to personnel.
2.
Disconnect two springs (1) from tow cylinders (2).
TM 9-2320-342-10-1
0081
0081-1
Back to Top
