TM-9-2320-342-10-1
TRUCK, WRECKER, 8X8 M984A4
TECHNICAL MANUAL; OPERATOR'S MANUAL
OCTOBER 2008
TM-9-2320-342-10-1 - Page 1119 of 1428
OPERATOR MAINTENANCE
REAR BEACON LIGHT OPERATION
INITIAL SETUP:
Not Applicable
SET UP REAR BEACON LIGHTS
NOTE
•
Beacon lights should remain in raised position except for crane
operations.
•
Driver side and passenger side beacon lights are set up in the same
way.
1.
Remove two nuts (1), lockwashers (2), washers (3), and screws (4) from support
bracket (5).
Figure 1.
CAUTION
Do not let beacon drop when raising it to operating position. Damage to
beacon can result.
2.
Raise beacon support tube (6) until lower set of holes in beacon support tube align
with holes in support bracket (5).
TM 9-2320-342-10-1
0093
0093-1
Back to Top
