TM-9-2320-343-10

TRUCK, CARGO, 8X8 M985A4 W/WINCH AND M985A4 W/O WINCH

TECHNICAL MANUAL; OPERATOR'S MANUAL

OCTOBER 2008

TM-9-2320-343-10 - Page 730 of 1128

DECISION

Hydraulic fluid is below normal operating temperature. - Test 3 - Does hydraulic fluid

reach normal operating temperature after cycling mast control down?Test 4 - Is

hydraulic fluid overheated?

Hydraulic fluid is at normal operating temperature. - Test 5 - Do crane controls operate

normally after hydraulic fluid is at normal operating temperature?

TEST 3 - Does hydraulic fluid reach normal operating temperature after cycling mast

control down?

WARNING

Reservoir may be very hot. Use care when placing hand near reservoir.

Reservoir can become hot enough to cause serious burns. Be careful not

to touch the reservoir with bare hands or allow body to contact reservoir.

Use gloves and insulated pads as necessary. Failure to comply may re-

sult in injury or death to personnel.

1.

Lower crane to stowed position. (WP 0038)

2.

Operate MAST control DOWN. (WP 0038) Hold MAST control DOWN for approximately

30 seconds, then return control to NEUTRAL position. Repeat procedure several times

until hydraulic fluid is warmed.

TM 9-2320-343-10

0122

0122-4