2
3
1
Figure 1.
2.
Turn knob (2) counterclockwise until knob (2) can be pulled out.
3.
Push and pull knob (2) on priming pump (3) until fuel appears at air bleed plug (1).
4.
Tighten air bleed plug (1).
5.
Push and pull knob (2) until strong resistance is felt.
CAUTION
Fuel priming pump knob must be in locked position prior to starting en-
gine. Failure to comply may result in damage to equipment.
6.
Push knob (2) in and turn clockwise until locked.
CAUTION
If engine fails to start within 30 seconds, turn ignition switch to OFF and
allow starter motor to cool at least two minutes before trying again. Failure
to comply may result in damage to equipment.
NOTE
If vehicle does not start after three attempts, contact field level mainte-
nance.
TM 9-2320-346-10
0158
0158-2