TM-9-2320-346-10

TRUCK, COMMON BRIDGE TRANSPORT (CBT), 8X8 M1977A4 W/WINCH AND M1977A4 W/O WINCH

TECHNICAL MANUAL; OPERATOR'S MANUAL

OCTOBER 2008

TM-9-2320-346-10 - Page 492 of 1184

CAUTION

Jack placement is critical to avoid damaging vehicle suspension compo-

nents. Follow jack placement notes and procedures carefully. Failure to

comply may result in damage to equipment.

NOTE

•

Jack ram should be fully screwed down (making jack as short as

possible) for Step (7).

•

Center jack on flat spot in center of transverse beam casting.

7.

Place jack base plate (5), and jack (6) under transverse beam casting (7).

7

6

5

Figure 27.

NOTE

If possible, unscrew jack ram until it contacts jacking point on equalizing

beam.

8.

Raise vehicle until axle (8) is as close as it will go to axle stop (9).

TM 9-2320-346-10

0082

0082-20