TM-9-2320-346-10

TRUCK, COMMON BRIDGE TRANSPORT (CBT), 8X8 M1977A4 W/WINCH AND M1977A4 W/O WINCH

TECHNICAL MANUAL; OPERATOR'S MANUAL

OCTOBER 2008

TM-9-2320-346-10 - Page 781 of 1184

OPERATOR MAINTENANCE

SLAVE START VEHICLE

INITIAL SETUP:

Not Applicable

PREPARE ASSIST VEHICLE

NOTE

This procedure is a two soldier task.

1.

Start engine of assist vehicle. (WP 0047)

NOTE

•

Model of truck can be determined by information plate on inside of

driver side cabin door.

•

Base Model HEMTT - Slave receptacle may be located either on

battery box or driver side front fender.

•

A2 Model HEMTT - Slave receptacle is located on driver side front

fender.

•

A4 Model HEMTT - Slave receptacle is located on driver side front

fender.

2.

Move assist vehicle into position beside disabled vehicle so slave receptacles (1) on

both vehicles are side by side.

////////////////////////////////////////////////////////////////////////////////////

TM 9-2320-346-10

0113

0113-1

////////////////////////////////////////////////////////////////////////////////////

////////////////////////////////////////////////////////////////////////////////////////////////////////////////////