TM 9-2320-361-24-1
0090 00
0090 00-3/4 blank
WIRING HARNESS CONNECTOR REPAIR (Contd)
END OF WORK PACKAGE
CONNECTOR ASSEMBLY REPAIR
NOTE
Refer to TC 9-237 for soldering instructions.
1.
Strip cable insulation (13) to depth of solder wells (16) on inserts (17).
2.
Slide cable ends (20) through grommet retaining nut (14) and grommet (15).
3.
Place cable ends (20) into solder wells (16) and solder.
4.
Slide grommet (15) over inserts (17) and press into shell assembly (18) until seated.
5.
Screw grommet retaining nut (14) on shell assembly (18) and coupling nut (19) until seated.
RECEPTACLE ASSEMBLY REPAIR
1.
Strip cable insulation (21) to depth of solder wells (25) on inserts (26).
2.
Slide cable ends (23) through grommet retaining nut (22) and grommet (24).
3.
Place cable ends (23) into solder wells (25) and solder.
4.
Slide grommet (24) over inserts (26) and press into receptacle (27) until seated.
5.
Screw grommet retaining nut (22) onto receptacle (27) until seated.
6.
Connect battery ground cable (WP 0126 00).
7.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
21
22
23
24
25
26
27
25
26
13
14
20
15
16
17
18
19
16
17