TM-9-2320-361-24-1
2-1/2 TON, 6X6, M44A2 SERIES TRUCKS
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE PART 1 OF 2
AUGUST 2006
TM-9-2320-361-24-1 - Page 834 of 1176
TM 9-2320-361-24-1
0123 00
0123 00-2
BLACKOUT DRIVE LAMP AND HOUSING REPLACEMENT (Contd)
BLACKOUT DRIVE LAMP REMOVAL
1.
Loosen three screws (2) and remove lens cover (1), three gaskets (9), and gasket (8) from blackout
drive lamp housing (4). Discard gaskets (9) and gasket (8).
2.
Remove lamp (3) from blackout drive lamp housing (4).
BLACKOUT DRIVE LAMP HOUSING REMOVAL
NOTE
Prior to removal, tag all lead wires for installation.
1.
Remove wire (5) from connector plug (6).
2.
Remove nut (17), lockwasher (18), ground wire (16), mounting washers (19) and (7), and blackout
drive lamp housing (4) from bracket (11). Discard lockwasher (18).
3.
Remove eight nuts (14), seven lockwashers (15), lockwasher (13), clamp (12), bracket (11), and four
shock mounts (10) from plate (20). Discard lockwashers (15) and (13).
BLACKOUT DRIVE LAMP HOUSING INSTALLATION
1.
Install four shock mounts (10) and bracket (11) on plate (20) with seven new lockwashers (15),
clamp (12), new lockwasher (13), and eight nuts (14).
2.
Install blackout lamp housing (4) on bracket (11) with mounting washers (19) and (7), ground
wire (16), new lockwasher (18), and nut (17).
3.
Connect wire (5) to connector plug (6).
BLACKOUT DRIVE LAMP INSTALLATION
1.
Install lamp (3) in blackout drive lamp housing (4).
2.
Install new gasket (8), three new gaskets (9), and lens cover (1) on blackout drive lamp housing (4)
with three screws (2).
3.
Connect battery ground cable (WP 0126 00).
4.
Lower hood and secure (TM 9-2320-361-10).
5.
Check operation of blackout drive lamp (TM 9-2320-361-10).
6.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
Back to Top
