TM-9-2320-361-24-2

2-1/2 TON, 6X6, M44A2 SERIES TRUCKS

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE PART 2 OF 2

AUGUST 2006
TM-9-2320-361-24-2

  TM-9-2320-361-24-2 - Page 126 of 1144

TM 9-2320-361-24-2
0220 00
0220 00-2
HOOD FASTENERS REPLACEMENT (Contd)
NOTE
Hood holddown, companion seat fastener, and windshield
holddown fasteners are replaced basically the same. Some
fasteners have additional hardware and reinforcements. This
procedure covers the hood holddown fastener only.
HOOD HOLDDOWN FASTENER AND BRACKET REMOVAL
1.
Unlatch fastener (15) from bracket (13).
2.
Raise and secure hood (10).
3.
Remove two locknuts (11), screws (16), and fastener (15) from brush guard (17) Discard
locknuts (11).
4.
Remove two locknuts (12), screws (14), and bracket (13) from hood (10). Discard locknuts (12).
SAFETY LATCH REMOVAL
Remove two locknuts (20), screws (18), and safety latch (19) from hood (10). Discard locknuts (20).
HOOD SUPPORT HOOK REMOVAL
1.
Lower hood (10).
2.
Remove hook (7) from clip (9).
3.
Remove screw (8) and clip (9) from cowling (1).
4.
Remove locknut (3), washer (4), nut (6), and hook (7) from bolt (5). Discard locknut (3).
5.
Remove locknut (2) and bolt (5) from cowling (1). Discard locknut (2).
HOOD SUPPORT HOOK INSTALLATION
1.
Install nut (6), bolt (5), washer (4), and new locknut (3) on hook (7). Install assembled hook (7) on
cowling (1) with new locknut (2).
2.
Install clip (9) on cowling (1) with screw (8).
3.
Install hook (7) on clip (9).
SAFETY LATCH INSTALLATION
1.
Raise and secure hood (10).
2.
Install safety latch (19) on hood (10) with two screws (18) and new locknuts (20).
HOOD HOLDDOWN FASTENER AND BRACKET INSTALLATION
1.
Install bracket (13) on hood (10) with two screws (14) and new locknuts (12).
2.
Install fastener (15) on brush guard (17) with two screws (16) and new locknuts (11).
3.
Lower and secure hood (10).
4.
Latch fastener (15) on bracket (13).
5.
Raise left side panel and secure (TM 9-2320-361-10).
6.
Connect battery ground cable (WP 0126 00).
7.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).


Back to Top