TM-9-2320-361-24-2

2-1/2 TON, 6X6, M44A2 SERIES TRUCKS

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE PART 2 OF 2

AUGUST 2006

TM-9-2320-361-24-2 - Page 164 of 1144

TM 9-2320-361-24-2

0231 00

0231 00-2

REAR CAB MOUNT REPLACEMENT (Contd)

WARNING

Do not place fingers between frame and crossmember while

replacing mount. Doing so may result in injury to personnel.

NOTE

Assistant will help with entire procedure.

REMOVAL

1.

Remove two rear cab mount locknuts (9), washers (8), screws (2), springs (4), and four washers (3)

from bracket (5) and frame (7). Discard locknuts (9).

WARNING

Support cab body while in raised position for mount

replacement. Failure to do so may result in injury to personnel.

CAUTION

Do not raise rear of cab too high when removing mounts.

Damage to cab may result.

2.

Raise cab (1) to provide clearance and remove two mounts (6) from frame (7).

3.

Remove four screw-assembled lockwashers (10) and bracket (5) from lower cab (1). Discard screw-

assembled lockwashers (10).

INSTALLATION

1.

Install bracket (5) on lower cab (1) with four new screw-assembled lockwashers (10).

2.

Install two new mounts (6) on frame (7).

3.

Lower cab (1) on mounts (6).

4.

Install two springs (4) and four washers (3) on two screws (2), and install screws (2) through

bracket (5), mounts (6), and frame (7).

5.

Install two washers (8) and two new locknuts (9) on screws (2). Tighten locknuts (9) to compress

springs (4) to height of 1.78 in. (4.52 cm).

6.

Connect battery ground cable (WP 0126 00).

7.

Release parking brake and remove wheel chocks (TM 9-2320-361-10).