TM-9-2320-362-14-P
TRUCK UTILITY: S250 SHELTER CARRIER, 4X4, M1037 FOR TRAFFIC JAM AN/TLQ-17A(V)3 (HMMWV)
TECHNICAL MANUAL; OPERATOR, UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST FOR ELECTRICAL ENVIRONMENTAL SYSTEM (EES)
APRIL 1992
TM-9-2320-362-14-P - Page 58 of 353
TM 9-2320-362-14&P
3-15. HAND THROTTLE CABLE REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
Manual Reference
General mechanic’s tool kit:
TM 9-2320-280-10
automotive (Item 1, Section III,
Equipment Condition
Appendix B)
Engine shut off (TM 9-2320-280-10)
1.
Loosen nut (4) and star washer (5) on hand throttle cable (2) and
detach hand throttle cable (2) from bracket (3).
2.
Loosen nut (7) and washers (6) on hand throttle cable (2) and
detach hand throttle cable (2) from bracket (l).
3.
Remove hitch pin (10) and washer (11).
Disconnect clevis (8)
from accelerator rod (9) and remove hand throttle cable (2).
b. Installation
NOTE
Hand throttle cable should be positioned with
no tension on cable.
1.
Install clevis (8) to accelerator rod (9) and secure with washer (11)
and hitch pin (10).
2.
Install hand throttle cable (2) to bracket (1) and secure with
washers (6) and nut (7).
3.
Install hand throttle cable (2) to bracket (3) and secure with
star washer (5) and nut (4).
3-28
Back to Top
