TM-9-2320-365-10
M1078 SERIES, 2-1/2 TON, 4x4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)
OPERATOR'S INSTRUCTIONS MANUAL
AUGUST 2005
CHANGE 2
TM-9-2320-365-10 - Page 571 of 836
TM 9-2320-365-10
Change 2
3-38.1/(3-38.2 Blank)
Table 3-2.
Troubleshooting (Cont)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
e21.
AUXILIARY PANEL DOES NOT ILLUMINATE (CONT).
(e)
Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance.
(f)
Position main light switch to OFF (para 2-21c).
(g)
Install PDP cover (para 3-13b).
(h)
If auxiliary panel still does not illuminate, notify Unit Maintenance.
e22.
HIGH ENGINE TEMPERATURE INDICATOR DOES NOT ILLUMINATE.
Check circuit breaker (CB77) in PDP to see if it is tripped.
(a)
Remove PDP cover (para 3-13a).
(b)
Position main light switch to OFF (para 2-21c).
(c)
If circuit breaker is tripped, push in to reset.
(d)
Position main light switch to SER DRIVE (para 2-21c).
(e)
Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance.
(f)
Position main light switch to OFF (para 2-21c).
(g)
Install PDP cover (para 3-13b).
(h)
If high engine temperature indicator still does not illuminate, notify Unit Maintenance.
e22a.
HIGH ENGINE TEMPERATURE INDICATOR ILLUMINATES
Does WATER TEMP gage read below 216°F (102°C) when high engine temperature indicator
illuminates?
(a)
Start engine (para 2-21a or b).
If WATER TEMP gage does not read above 216°F (102°C), nofity Unit Maintenance.
If WATER TEMP gage does read above 216°F (102°C), perform Cooling System
Troubleshooting (d1. Engine Overheats).
(b)
Shut down engine (para 2-21f).
e23.
CENTRAL TIRE INFLATION SYSTEM (CTIS) OVERSPEED INDICATOR DOES NOT
ILLUMINATE.
Check circuit breaker (CB40) in PDP to see if it is tripped.
(a)
Remove PDP cover (para 3-13a).
(b)
Position main light switch to OFF (para 2-21c).
(c)
If circuit breaker is tripped, push in to reset.
(d)
Position main light switch to SER DRIVE (para 2-21c).
Back to Top
