TM-9-2320-365-20-1

M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-365-20-1 - Page 1303 of 1760

TM 9-2320-365-20-1

Change 2

2-907

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

CONTINUITY TEST

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

CAUTION

NOTE

(1) Start engine (TM 9-2320-365-10).

(2) Allow air pressure to build until FRONT BRAKE

AIR and REAR BRAKE AIR pressure gages read

approximately 120 PSI.

(3) Shut down engine (TM 9-2320-365-10).

(4) Disconnect connector P110 from CTIS ECU.

(5) Set multimeter to ohms.

(6) Connect positive (+) probe of multimeter to

connector P110 socket T.

(7) Connect negative (-) probe of multimeter to

known good ground and note reading on

multimeter.

(8) If continuity is not present, go to step 21 of

this fault.