TM 9-2320-365-20-1
Change 2
2-1009
VOLTAGE TEST
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle.
Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
WARNING
(1) Set multimeter to volts DC.
(2) Connect positive (+) probe of multimeter to
PDP, terminal 86, where WTEC III relay K37
was removed.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) If 24 VDC is not present, replace WTEC III
transmission ECU (para 8-7).
(5) If 24 VDC is present, replace WTEC III relay
K37 (para 7-9).
(6) Install WTEC III relay K37 on PDP.
(7) Remove PTO switch from connector P904.
(8) Install personnel heater (para 18-9).