TM-9-2320-365-20-1

M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-365-20-1 - Page 539 of 1760

CONTINUITY TEST

(1)

Remove personnel heater assembly for

access (para 18-9).

(2)

Disconnect connector P913 from

connector J913.

(3)

Set multimeter to ohms.

(4)

Connect positive (+) probe of multimeter

to connector P901 pin 4.

(5)

Connect negative (-) probe of multimeter

to connector P913 pin 12 and note reading

on multimeter.

(6)

If continuity is not present, repair wire 1550

from connector P901 pin 4 to connector

P913 pin 12 (para 2-40) or replace auxiliary

panel cable assembly (para 7-49).

(7)

If continuity is present, repair wire 1550

from connector J913 socket 12 to

connector PX26 socket 1 (para 2-40) or

replace WTEC II dashboard cable assembly

(para 7-10) or WTEC III dashboard cable

assembly (para 7-11).

(8)

Connect connector P913 to connector

J913.

(9)

Install personnel heater assembly (para

18-9).

CAUTION

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

NOTE

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

Change 1

2-356.5

TM 9-2320-366-20-1