TM-9-2320-365-20-2
M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 2 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-365-20-2 - Page 985 of 1432
TM 9-2320-365-20-2
TM 9-2320-365-20-2
TM 9-2320-365-20-2
TM 9-2320-365-20-2
TM 9-2320-365-20-2
WINCH CONTROL VALVE PRESSURE TEST
(12)
Disconnect STE/ICE-R and tee.
(13)
Connect hose fitting to port V1.
(14)
Disconnect hose (below elbow) from
port V2.
(15)
Connect STE/ICE-R with tee between
hose and port V2.
(16)
Start engine (TM 9-2320-365-10).
(17)
Position PTO and WINCH POWER
switches to on (TM 9-2320-365-10).
(18)
Perform STE/ICE-R test #51 and
toggle WINCH IN/OUT switch to OUT
(TM 9-4910-571-12&P).
(19)
Check if pressure reading is between
2000-2100 psi (13790-14480 kPa).
(20)
If pressure is lower than 2000 psi, notify
DS Maintenance.
(21)
Release load and retrieve cable
(TM 9-2320-365-10).
(22)
Position WINCH POWER and PTO
switches to off (TM 9-2320-365-10).
(23)
Disengage winch clutch (TM
9-2320-365-10).
(24)
Shut down engine (TM 9-2320-365-10).
(25)
Disconnect STE/ICE-R and tee.
(26)
Connect hose fitting to port V2.
(1)
Disconnect hose from fitting below
elbow at port V1 (on side of
11K self-recovery winch toward front of
vehicle).
(2)
Connect STE/ICE-R with tee between
port V1 and hose.
(3)
Start engine (TM 9-2320-365-10).
(4)
Attach stall load to winch cable
(TM 9-2320-365-10).
(5)
Position PTO switch and WINCH
POWER switch to ON (TM
9-2320-365-10).
(6)
Engage winch clutch (TM
9-2320-365-10).
(7)
Perform STE/ICE-R test #51 and toggle
WINCH IN/OUT switch to IN position
and hold (TM 9-4910-571-12&P).
(8)
Check if pressure reading is between
2000-2100 psi (13790-14480 kPa) on
STE/ICE-R.
(9)
If pressure is less than 2000 psi
(13790 kPa), notify DS Maintenance.
(10)
Position WINCH POWER and PTO
switches to off (TM 9-2320-365-10).
(11)
Shut down engine (TM 9-2320-365-10).
2-1949
2-1949
2-1949
2-1949
2-1949
Back to Top
