TM 9-2320-365-20-5
21-8.2
Change 2
21-5.
MACHINE GUN RING CENTER SEAT REPLACEMENT (CONT)
b.
Installation.
(1)
Apply sealing compound to threads of two screws (1).
(2)
Position center seat (2) on platform (3).
(3)
Position two washers (4) and screws (1) in seat
mount (5).
(4)
Position two spacers (5.1), washers (4), and
screws (1) in seat mounts (5).
(5)
Slide center seat (2) fully forward.
(6)
Fold center seat (2) down.
WARNING
Adhesive sealant MIL-S-46163 can damage
your eyes.
Wear safety goggles/glasses when
using; avoid contact with eyes.
If sealant
contacts eyes, flush eyes with water and get
immediate medical attention.
Failure to
comply may result in injury to personnel.
NOTE
•
Flat sides of screw will be in line with
seat tracks.
•
Perform step (3) on vehicles with cabs
S/N 12075G or lower.
NOTE
•
Perform step (2) on vehicles with cabs
S/N 12075G or lower. Cab S/N located
on B pillar.
•
Install center seat in folded and raised
position with seat rails in the forward
position.
NOTE
Perform step (4) on vehicles with cabs S/N
12076G or higher.