TM-9-2320-365-34-1

M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 1 OF 2

AUGUST 2005

CHANGE 2

TM-9-2320-365-34-1 - Page 169 of 1334

Change 1

2-83

TM 9-2320-365-34-1

CONTINUITY TEST

(1)

Remove control valve module (para 7-10).

(2)

Remove four screws and cover from

control valve module.

(3)

Disconnect internal wiring harness

connector TSS from turbine speed sensor.

(4)

Set multimeter to ohms.

(5)

Connect positive (+) probe of multimeter

to internal wiring harness 31-pin connector

pin V.

(6)

Connect negative (-) probe of multimeter

to internal wiring harness connector TSS

pin A and note reading on multimeter.

(7)

If continuity is not present, replace

transmission internal wiring harness

(para 7-13).

(8)

Connect positive (+) probe of multimeter

to internal wiring harness 31-pin connector

pin V.

(9)

Connect negative (-) probe of multimeter

to ground and note reading on multimeter.

(10)

If continuity is present, transmission

internal wiring harness is shorted; replace

transmission internal wiring harness

(para 7-13).

CAUTION

Use care when disconnecting wiring harness

connectors. Failure to comply may result

in damage to equipment.