TM-9-2320-365-34-2
M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 2
AUGUST 2005
CHANGE 2
TM-9-2320-365-34-2 - Page 663 of 1414
TM 9-2320-365-34-2
Change 2
14-5
b. Installation
(1)
Install C-Clamp on leaf spring (1).
(2)
Position bolt (2) on leaf spring (1) with self-locking
nut (3).
(3)
Tighten bolt to 69-79 lb-ft (90-110 N•m).
(4)
Position plate (4) on bolt (2).
(5)
Position two U-bolts (5), four washers (6), and self-
locking nuts (7) on plate (4).
(6)
Tighten four self-locking nuts (7) to 200 lb-ft (271
N•m) to 390-510 lb-ft (529-692 N•m), in sequence
shown.
(7)
Re tighten four self-locking nuts (7) in increments
of 50 lb-ft (68 N•m) to 390-510 lb-ft (529-692
N•m), in sequence shown.
(8)
Apply sealant to threads of bolt (2).
(9)
Position spacer (8) and enhanced resilient mount
(9) on bolt (2).
(10) Tighten enhanced resilient mount (9) 1 1/2 turns after
contact with plate (4).
(11) Remove C-Clamp.
NOTE
•
Vehicles S/N 11,438 through 13,302 were
originally equipped with three leaf springs.
When replacing a three leaf spring with a four
leaf spring, both sides must be replaced.
•
Vehicles S/N 13,303 through 16,156 were
originally equipped with standard resilient
mounts attached with bolts and washers.
If
leaf spring has this configuration, perform
Enhanced Resilient Mount Initial Install action
(M18-12 linked) and upgrade all six resilient
mount to kit P.N 57K2003.
Back to Top
