TM-9-2320-365-34-2
M1078 SERIES, 2 1/2-TON, 4 X 4, LIGHT MEDIUM TACTICAL VEHICLES (LMTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 2
AUGUST 2005
CHANGE 2
TM-9-2320-365-34-2 - Page 92 of 1414
TM 9-2320-365-34-2
3-46
Change 2
3-3.
ENGINE ASSEMBLY REPLACEMENT (CONT)
(75) Position terminal lugs TL5 (93), TL6 (94), TL60 (95),
and TL2 (96) in clamp (97).
(76) Remove screw (98) and washer (99) from alternator
(5).
(77) Position clamp (97) on alternator (5) with washer
(99) and screw (98).
(78) Tighten screw (98) to 80 lb-in. (9 N
•
m).
(79)
Apply electrical tape to terminal lug TL110 (103).
(79.1)
Remove self-locking nut (100) and washer (101)
from voltage regulator (102).
(80)
Position terminal lug TL110 (103) on voltage
regulator (102) with washer (101) and self-locking
nut (100).
(81)
Tighten self-locking nut (100) to 20 lb-in. (2 N
•
m).
(82)
Position boot on terminal lug TL110 (103).
(83) Remove self-locking nut (104) and washer (105)
from voltage regulator (102).
(84) Position terminal lug TL35 (106) on voltage regulator
(102) with washer (105) and self-locking nut (104).
(85)
Tighten self-locking nut (104) to 20 lb-in. (2 N
•
m).
(86)
Position boot on terminal lug TL35 (106).
NOTE
Perform steps (75) through (98) on vehicles
equipped with 100 Amp alternator.
NOTE
•
Perform step (79) if replacing alternator
P/N N1506-1 (12420852) with alternator
N1509-1 (12422863).
•
Install plastic cable ties to TL110 and tie
wire away from alternator.
NOTE
Perform
steps (79.1) through (82) on
alternator N1506-1 (12420852).
Back to Top
