TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1241 of 1824

CONTINUITY TEST

Change 1

2-687

TM 9-2320-366-20-1

(1) Remove three screws from PDP.

(2) Remove three screws and washers from

PDP.

(3) Lift PDP outward to gain access.

(4) Disconnect connector P51 from connector

J51.

(5) Set multimeter to ohms.

(6) Connect positive (+) probe of multimeter

to connector PX33 socket A1.

(7) Connect negative (-)

probe of multimeter to

connector J51 pin 2 and note reading on

multimeter.

(8) If continuity is not present, repair wire 490

from connector PX33 socket A1 to

connector J51 pin 2 (para 2-45) or replace

WTEC II dashboard cable assembly

(para 7-10).

(9) Connect connector PX33 to WTEC II VIM.

(10) Tighten screw in connector PX33.

(11) Install kick panel (para 16-3).

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

NOTE

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

CAUTION