TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1271 of 1824

VOLTAGE TEST

VOLTAGE TEST

TM 9-2320-366-20-1

Change 1

2-717/(2-718 Blank)

All data on pages 2-718 and 2-719 deleted.

WARNING

(1) Remove PDP cover (para 16-2).

(2) Remove circuit breaker CB71 from PDP.

(3) Remove relay K9 from PDP.

(4) Set multimeter to volts DC.

(5) Connect positive (+) probe of multimeter

to PDP, terminal 30, where relay K9 was

removed.

(6) Connect negative (-) probe of multimeter to

ground.

(7) Install circuit breaker CB71 in PDP and

and note reading on multimeter.

(8) If 12 VDC is not present, repair wire

1566 from relay K9 terminal 30 to circuit

breaker CB 71 (para 2-45) or replace

WTEC II dashboard cable assembly

(para 7-10) or WTEC III dashboard cable

assembly (para 7-11).

(1) Set multimeter to volts DC.

(2) Connect positive (+) probe of multimeter

to PDP, terminal 86, where relay K9 was

removed.

(3) Connect negative (-) probe of multimeter

to ground.

(4) Position main light switch to SER DRIVE

(TM 9-2320-366-10-1) and not reading on

multimeter.

(5) If 12 VDC is not present, repair wire

1514 from relay K9 terminal 86 to circuit

breaker CB74 (para 2-45) or replace

WTEC II dashboard cable assembly

(para 7-10) or WTEC III dashboard cable

assembly (para 7-11).

(6) Position main light switch to OFF

(TM 9-2320-366-10-1).

Remove rings, bracelets, watches, necklaces,

and any other jewelry before working around

vehicle.

Jewelry can catch on equipment and

cause injury or short across electrical circuits

and cause severe burns or electrical shock.