TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1359 of 1824

TM 9-2320-366-20-1

CONTINUITY TEST

CAUTION

NOTE

Change 1

2-795

(1) Disconnect connector P53R from connector

J53R.

(2) Set multimeter to ohms.

(3) Connect positive (+) probe of multimeter

to connector P51 socket 9.

(4) Connect negative (-) probe of multimeter

to connector P53R pin 2 and note

reading on multimeter.

(5) If continuity is not present, repair wire

489T from connector P51 socket 9

to connector P53R pin 2 (para 2-45)

or replace M1083/M1084/M1085/M1090/

M1092/M1093/M1094 rear lights cable

assembly (para 7-84) or M1086/M1088/

M1089 rear lights cable assembly

(para 7-104).

(6) If continuity is present, replace

intervehicular 24 VDC (12 pin) cable

(para 7-129).

(7) Connect connector P53R to connector J53R.

(8) Connect connector P51 to connector J51.

(9) Install PDP on dashboard with three

screws.

(10) Install three washers and screws in PDP.

(11) Install PDP cover (para 16-2).

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.