(1) Set multimeter to volts DC.
(2) Connect positive (+) probe of multimeter
to relay K30 terminal 30 on PDP.
(3) Connect negative (-) probe of multimeter
(4) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading
(5) If 24 VDC is not present, repair wire 1922
from K30 terminal 30 on PDP to circuit
breaker CB43 terminal 8 (para 2-45) or
replace WTEC II
assembly (para 7-10) or WTEC III
dashboaard cable assembly (para 7-11).
(6) Position main light switch to OFF
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
(1) Remove PDP cover (para 16-2).
(2) Remove relay K30 from PDP.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter
to connector J130 socket B.
(5) Connect negative (-) probe of multimeter
to relay K30 terminal 87 on PDP and note
reading on multimeter.
(6) If continuity is not present, go to step 6
of this fault.
Inspect connector pins/sockets for damage,
corrosion, and serviceability.
connector pins are not pushed back and
are capable of making good contact.
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes.
Failure to comply
may result in damage to equipment.