TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1389 of 1824

TM 9-2320-366-20-1

Change 1

2-825

CONTINUITY TEST

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

NOTE

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

CAUTION

(7) Connect connector P53R to connector J53R.

(8) Connect connector P51 to connector J51.

(9) Install PDP on dashboard with three

screws.

(10) Install three washers and screws in PDP.

(11) Install PDP cover (para 16-2).

(1) Disconnect connector P53R from connector

J53R.

(2) Set multimeter to ohms.

(3) Connect positive (+) probe of multimeter

to connector P51 socket 10.

(4) Connect negative (-) probe of multimeter

to connector P53R sockets 7 and 9 and pin

10, one at a time, and note reading on

multimeter.

(5) If continuity is not present, repair wire

484T from connector P51 socket 10

to connector P53R socket 7 or 9 or pin 10

(para 2-45) or replace M1083/M1084/

M1085/M1090/M1092/M1093/M1094

rear lights cable assembly (para 7-84)

or M1086/M1088/M1089 rear lights cable

assembly (para 7-104).

(6) If continuity is present, replace

intervehicular 24 VDC (12 pin) cable

(para 7-129).