TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 387 of 1824

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

CAUTION

NOTE

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back or not

capable of making good contact.

CONTINUITY TEST

(1) Disconnect batteries (para 7-57).

(2) Remove kick panel (para 16-3).

(3) Disconnect connector clamp from

connector P115.

(4) Disconnect connector P115 from WTEC III

transmission ECU connector.

(5) Set multimeter to ohms.

(6) Connect positive (+) probe of multimeter

to relay K26 socket 86.

(7) Connect negative (-) probe of multimeter to

connector P115 socket 8 and note

reading on multimeter.

(8) If continuity is not present, repair wire 123

from relay K26 socket 86 to connector

P115 socket 8 (para 2-45) or replace

WTEC III dashboard cable assembly

(para 7-11).

(9) Connect connector P115 to WTEC III

transmission ECU connector.

(10) Connect connector clamp to connector

P115.

(11) Install relay K26 in PDP.

TM 9-2320-366-20-1

Change 1

2-257