TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 481 of 1824

CONTINUITY TEST

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

CAUTION

(10) Install instrument panel assembly (para

7-15).

(11) Connect batteries (para 7-57).

(1) Disconnect batteries (para 7-57).

(2) Remove instrument panel assembly for

access (para 7-15).

(3) Disconnect connector J31 from connector

P31.

(4) Set multimeter to ohms.

(5) Connect positive (+) probe of multimeter

to connector J31pin 5.

(6) Connect negative (-) probe of multimeter to

ground and note reading on multimeter.

(7) If continuity is not present, repair wire

3015 from connector J31 pin 5 to terminal

board TB2 position 18 on power

distribution panel (PDP) (para 2-45) or

replace WTEC II dashboard cable assembly

(para 7-10) or WTEC III dashboard cable

assembly (para 7-11).

(8) If continuity is present, repair wire 3015

from connector P31 socket 5 to terminal

lug TL29 (para 2-45) or replace engine

control cable assembly (para 7-80).

(9) Connect connector J31 to connector P31.

TM 9-2320-366-20-1

Change 1

2-315