TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006
CHANGE 3

  TM-9-2320-366-20-1 - Page 695 of 1824

CONTINUITY TEST
NOTE
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes.
Failure to comply
may result in damage to equipment.
Inspect connector pins/sockets for damage,
corrosion, and serviceability.
Check that
connector pins are not pushed back and
are capable of making good contact.
CAUTION
Change 2
2-418.5
TM 9-2320-366-20-1
(1) Raise cab (TM 9-2320-366-10-1).
(2) Disconnect connector clamp from coolant
temperature light switch connector,
(3) Disconnect connector P37 from coolant
temperature light switch.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter to
coolant temperature light switch connector
socket 2.
(6) Connect negative (-) probe of multimeter to
known good ground and note reading on
multimeter.
(7) If continuity is not present, go to step 3 of this
fault.
(8) If continuity is present, replace coolant
temperature light switch (para 7-22).
(9) Connect connector P37 to coolant
temperature light switch.
(10) Connect connector clamp to coolant
temperature light switch connector.
(11) Lower cab (TM 9-2320-366-10-1).


Back to Top