TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006
CHANGE 3

  TM-9-2320-366-20-1 - Page 713 of 1824

TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
2-425
2-425
2-425
2-425
2-425
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle.
Jewelry can catch on equipment and
cause injury or short across electrical circuit
and cause severe burns or electrical shock.
VOLTAGE TEST
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle.
Jewelry can catch on equipment and
cause injury or short across electrical circuit
and cause severe burns or electrical shock.
VOLTAGE TEST
(1)
Disconnect connector P110 from CTIS ECU.
(2)
Set multimeter to volts dc.
(3)
Connect positive (+) probe of multimeter to
connector P110-S.
(4)
Connect negative (-) probe of multimeter to
ground.
(5)
Position master power switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(6)
If 24 vdc is not present, go to step 8 of
this fault.
(7)
Position master power switch to off
(TM 9-2320-366-10-1).
(1)
Connect batteries (para 7-57).
(2)
Set multimeter to volts dc.
(3)
Connect positive (+) probe of multimeter to
PDP, terminal 30, where relay K52 was
removed.
(4)
Connect negative (-) probe of multimeter to
ground.
(5)
Position master power switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(6)
If 24 vdc is not present, repair wire 1911
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(7)
Position master power switch to off
(TM 9-2320-366-10-1).
(8)
Install relay K52 in PDP.
(9)
Install PDP cover (para 16-2).


Back to Top