TM-9-2320-366-20-1
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-1 - Page 879 of 1824
VOLTAGE TEST
(1)
Remove four screws from RH cab marker
light base.
TM 9-2320-366-20-1
(2)
Remove nut, lockwasher, terminal lug TL134,
and lockwasher from RH cab marker light
base.
Discard lockwashers.
(3)
Extend base and disconnect connector P132
from marker light connector.
(4)
Remove gasket from RH cab marker light
base.
Discard gasket.
(5)
Set multimeter to volts DC.
(6)
Connect positive (+) probe of multimeter
to connector P132 socket.
(7)
Connect negative (-) probe of multimeter
to ground.
(8)
Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading on
multimeter.
Change 1
2-573
NOTE
Do not let wires slip through hole into cab
structure.
If wires slip into cab structure,
vehicle will need further disassembly to
retrieve wires.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability.
Check that
connector pins are not pushed back and
are capable of making good contact.
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes.
Failure to comply
may result in damage to equipment.
CAUTION
WARNING
(14)
Install lockwasher, terminal lug TL134,
lockwasher, and nut on back of RH cab
marker light base.
(15)
Install RH cab marker light base on vehicle
with four screws.
(16)
Install RH cab marker light lamp in socket.
(17)
Install lens cover on base with two
screws.
VOLTAGE TEST (CONT)
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle.
Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
(9)
If 12 VDC is not present, repair wire 1947
from connector P132 socket to splice E22
(para 2-45) or replace RH door and cab
marker lights cable assembly (para 7-64).
(10)
If 12 VDC is present, replace RH cab marker
light (para 7-38).
(11)
Position main light switch to OFF
(TM 9-2320-366-10-1).
(12)
Install gasket on RH cab marker light base.
(13)
Connect marker light connector to connector
P132.
Back to Top
