CONTINUITY TEST
(1)
Set multimeter to ohms.
(2)
Connect positive (+) probe of multimeter to
terminal board TB1 position 60.
(3)
Connect negative (-) probe of multimeter to
terminal board TB1 position 62 and note
reading on multimeter.
(4)
If continuity is not present, replace
terminal board TB1 (para 7-11).
(5)
If continuity is present, Repair wire 1690
from terminal board TB1 position 62 to
circuit breaker CB79 (para 2-45) or replace
WTEC II dashboard cable assembly
(para 7-11).
(6)
Install PDP on dashboard with three screws.
(7)
Install three washers and screws in PDP.
(8)
Install PDP cover (para 16-2).
(9)
Connect batteries (para 7-57).
TM 9-2320-366-20-2
Change 1
2-1822.27