TM-9-2320-366-20-2
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 2 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-2 - Page 4 of 1632
TM 9-2320-366-20-2
WARNING SUMMARY (CONT)
WARNING
Battery acid (electrolyte) is extremely harmful. Always wear safety goggles and
rubber gloves, and do not smoke when performing maintenance on batteries.
Injury will result if acid contacts skin or eyes. Wear rubber apron to prevent
clothing being damaged. Failure to comply may result in injury to personnel.
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off
harmful vapors, and are harmful to skin and clothing. Keep away from open fire
and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets
on skin or clothing, wash immediately with soap and water. Failure to comply
may result in injury to personnel.
WARNING
Dry Cleaning Solvent (P-D-680) is TOXIC and flammable.
Wear protective
goggles and gloves; use only in well ventilated area; avoid contact with skin,
eyes, and clothes, and do not breathe vapors. Keep away from heat or flame.
Never smoke when using solvent; the flashpoint for Type I Dry Cleaning Solvent
is 100°F (38°C) and for Type II is 130°F (50°C). Failure to comply may result
in serious injury or death to personnel.
If personnel become dizzy while using Dry Cleaning Solvent, immediately get
fresh air and medical help. If Dry Cleaning Solvent contacts skin or clothes,
flush with cold water. If Dry Cleaning Solvent contacts eyes, immediately flush
eyes with water and get immediate medical attention. Failure to comply may
result in injury to personnel.
WARNING
Diesel fuel is flammable. If fuel is spilled, clean it up immediately. Failure to
comply may result in serious injury or death to personnel.
WARNING
Diesel fuel is flammable.
Do not fill fuel tank with engine running, while
smoking, or when near an open flame. Never overfill the tank or spill fuel. If
fuel is spilled, clean it up immediately. Failure to comply may result in serious
injury or death to personnel.
WARNING
Use care when removing/installing springs. Springs are under tension and can
act as projectiles when being removed. Failure to comply can cause injury to
personnel.
b
Back to Top
