TM-9-2320-366-20-2

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 2 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-2 - Page 945 of 1632

CAUTION

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

CONTINUITY TEST

Change 1

2-1707

TM 9-2320-366-20-2

NOTE

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

(1)

Connect connector J116 to WTEC II VIM.

(2)

Tighten screw in connector J116.

(3)

Remove instrument panel assembly for

access (para 7-15).

(4)

Disconnect connector J115 from WTEC II

TEPSS.

(5)

Set multimeter ohms.

(6)

Connect positive (+) probe of multimeter to

connector J115 socket 2.

(7)

Connect negative (-) probe of multimeter to

connector J115 socket 11 and note reading

on multimeter.

(8)

If continuity is not present, replace WTEC II

cab transmission harness (para 7-137).

(9)

If continuity is present, replace WTEC II

TEPSS (para 8-2).

(10)

Install kick panel (para 16-3).

(11)

Connect batteries (para 7-57).