TM-9-2320-366-20-4

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 4 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-4 - Page 320 of 1558

TM 9-2320-366-20-4

7-132. START AND CHARGING CABLE ASSEMBLY REPLACEMENT (CONT)

NOTE

Perform steps (13.1) through (14) on start

and charging cable assemblies equipped with

P81 connectors.

(13.1) Cut connector P81 (16) from start and charging cable

assembly (1).

(13.2) Remove band marker (17) from start and charging cable

assembly (1).

NOTE

Remove

electrical

tape

and

insulation

sleeving as required.

(13.3) Remove convoluted tubing (17.1) from two wires (17.2

and 17.3).

NOTE

Measure wires from body of start and

charging cable assembly.

(13.4) Cut wire (17.2) to 3 in. (7.6 cm) in length.

(13.5) Cut wire (17.3) to 4 in. (10.2 cm) in length.

(13.6) Remove 0.38 in. (1 cm) of insulation from two wires

(17.2 and 17.3).

(13.7) Cut insulation sleeving (17.4) 1.5 in. (3.8 cm).

(13.8) Position insulation sleeving (17.4) on wire (17.3).

(13.9) Install conductor splice (17.5) on two wires (17.2 and

17.3).

(13.10) Install insulation sleeving (17.4) on conductor splice

(17.5).

NOTE

Install electrical tape as required.

(14) Install convoluted tubing (17.1) on two wires (17.2 and

17.3).

7-650.2

Change 1