TM-9-2320-366-20-5

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 5 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-5 - Page 344 of 1158

TM 9-2320-366-20-5

19-7. CAB HYDRAULIC LATCH REPLACEMENT/ADJUSTMENT

This task covers:

a. Removal

b. Installation

c. Adjustment

d. Follow-On Maintenance

INITIAL SETUP

Equipment Conditions

Engine shut down (TM 9-2320-366-10-1).

Cab raised (TM 9-2320-366-10-1).

Tools and Special Tools

Tool Kit, Genl Mech (Item 46, Appendix C)

Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)

Pan, Drain (Item 24, Appendix C)

Goggles, Industrial (Item 15, Appendix C)

Gloves, Rubber (Item 13, Appendix C)

Materials/Parts

Cap and Plug Set (Item 14, Appendix D)

Hydraulic Fluid A (Item 25, Appendix D)

Nut, Self-Locking (4) (Item 168, Appendix G)

a. Removal.

(1) Position drain pan under hydraulic hose (1).

WARNING

Hydraulic fluid (MIL-H-5606) is TOXIC.

Wear protective goggles and gloves; use

only in well ventilated area; avoid

contact with skin, eyes, and clothes.

Skin and clothing that come in contact

with hydraulic oil should be washed

immediately. Saturated clothing should

be removed immediately. Failure to

comply may result in injury to

personnel.

CAUTION

Cap or plug hydraulic hose and connection

point to prevent contamination of hydraulic

system. Failure to comply may result in

damage to equipment.

(2) Disconnect hydraulic hose (1) from 90-degree fitting

(2).

(3) Remove four self-locking nuts (3), washers (4), screws

(5), and hydraulic latch (6) from cab support assembly

(7). Discard self-locking nuts.

(4) Remove 90-degree fitting (2) from hydraulic latch (6).

19-32

Change 1