TM-9-2320-366-34-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 1 OF 4

AUGUST 2005

CHANGE 2

TM-9-2320-366-34-1 - Page 406 of 1591

Change 1

2-267

TM 9-2320-366-34-1

RESISTANCE TEST

NOTE

CAUTION

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

(1)

Set multimeter to ohms.

(2)

Connect positive (+) probe of multimeter to

C solenoid connector pin A.

(3)

Connect negative (-) probe of multimeter to

C solenoid connector pin B and note reading

on multimeter.

(4)

If resistance is less than 2.5 ohms or

greater than 5.0 ohms, replace C solenoid

(para 7-7).

(5)

If resistance is between 2.5-5.0 ohms,

replace WTEC II TEPSS (TM 9-2320-366-

20-4).

(6)

Connect internal wiring harness connector C

to C solenoid connector.

(7)

Install cover on control valve module with

four screws.

(8)

Install control valve module (para 7-10).

(9)

Connect batteries (TM 9-2320-366-20-3).