TM 9-2320-366-34-1
Change 1
2-781
CONTINUITY TEST
(1)
Set multimeter to ohms.
(2)
Connect positive (+) probe of multimeter
to internal wiring harness 24-pin connector
pin B2.
(3)
Connect negative (-) probe of multimeter
to internal wiring harness connector E
pin B and note reading on multimeter.
(4)
If continuity is not present, replace
transmission internal wiring harness
(para 7-13).
(5)
Connect positive (+) probe of multimeter
to internal wiring harness 24-pin connector
pin B2.
(6)
Connect negative (-) probe of multimeter
to all other pins in internal wiring harness
24-pin connector, except pin B1, and note
reading on multimeter.
(7)
Connect negative (-) probe of multimeter
to ground and note reading on multimeter.
(8)
If continuity is present, transmission
internal wiring harness is shorted; replace
transmission internal wiring harness
(para 7-13).