TM-9-2320-366-34-2

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 4

AUGUST 2005

CHANGE 2

TM-9-2320-366-34-2 - Page 415 of 1434

TM 9-2320-366-34-2

7-10. CONTROL VALVE MODULE REPLACEMENT

This task covers:

a. Removal

b. Installation

c. Follow-On Maintenance

INITIAL SETUP

Equipment Conditions

Engine shut down (TM 9-2320-366-10-1).

Front drive shaft removed (TM 9-2320-366-20-4).

Transmission oil filters removed (TM 9-2320-366-20-

4).

Tools and Special Tools

Tool Kit, Genl Mech (Item 78, Appendix B)

Wrench, Torque, 0-175 lb-ft (Item 92, Appendix B)

Wrench, Torque, 0-150 lb-in. (Item 91, Appendix B)

Jack, Dolly Type, Hydraulic (Item 37, Appendix B)

Goggles, Industrial (Item 28, Appendix B)

Tools/Special Tools (Cont)

Wrench Set, Socket (Item 85, Appendix B)

Materials/Parts

Screw, Cap, Hex Head (3) (M10x1.5x55) (Item 77,

Appendix C)

Nut, Self-Locking (2) (Item 173, Appendix F)

Seal (Item 376, Appendix F)

Gasket (Item 64, Appendix F)

Lubricating Oil, Gear (Item 50, Appendix C)

Personnel Required

(2)

WARNING

•

Wear appropriate eye protection when

working under vehicle due to the

possibility of falling debris. Failure to

comply may result in injury to personnel.

• Ensure exhaust system is cool before

performing maintenance. Failure to comply

may result in injury to personnel.

a. Removal.

(1) Remove self-locking nut (1) from clamp (2). Discard

self-locking nut.

(2) Disconnect lower exhaust pipe (3) from muffler (4).

(3) Remove clamp (2) from lower exhaust pipe (3).

Change 1

7-69