TM-9-2320-386-24-1-1
2-1/2-TON, 6X6, M44A3 SERIES TRUCKS (DIESEL)
TECHNICAL MANUAL; EXTENDED SERVICE PROGRAM (ESP); UNIT, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL; VOLUME 1 OF 2
MAY 2001
TM-9-2320-386-24-1-1 - Page 454 of 1078
0115 00-2
TM 9-2320-386-24-1-1
0115 00
FUEL LEVEL SENDING UNIT REPLACEMENT (Contd)
WARNING
Diesel fuel is flammable. Do not perform fuel system procedures
near open flame. Failure to comply may result in injury to
personnel.
REMOVAL
1.
Disconnect lead 28 (1) from sending unit (6).
2.
Remove screw (3), washer (2), ground (GND) lead (4), and lockwasher (5) from sending unit (6).
Discard lockwasher (5).
3.
Remove four screws (11) and washers (10) from sending unit (6).
4.
Remove sending unit (6) and gasket (7) from fuel tank (8). Discard gasket (7).
INSTALLATION
1.
Guide floater arm (9) and install new gasket (7) and sending unit (6) on fuel tank (8) with four
washers (10) and screws (11).
2.
Install ground (GND) lead (4) on sending unit (6) with new lockwasher (5), washer (2), and
screw (3).
3.
Connect lead 28 (1) to sending unit (6).
4.
Connect battery ground cable (WP 0121 00).
5.
Start engine (TM 9-2320-386-10) and check fuel gauge for proper operation.
Back to Top
