TM-9-2320-386-24-1-1

2-1/2-TON, 6X6, M44A3 SERIES TRUCKS (DIESEL)

TECHNICAL MANUAL; EXTENDED SERVICE PROGRAM (ESP); UNIT, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL; VOLUME 1 OF 2

MAY 2001

  TM-9-2320-386-24-1-1 - Page 744 of 1078

WARNING
Keep fingers clear of hood and cowling when replacing hinges.
Failure to do so may result in injury to personnel.
REMOVAL
1.
Turn four lockstuds (3) 1/4-turn to left and pull instrument cluster (2) away from instrument
panel (1).
NOTE
Assistant will help with steps 2 through 6.
2.
Remove eight screws (5), lockwashers (4), and two reinforcements (15) from cowling (16). Discard
lockwashers (4).
3.
Remove two holddown latches (10) from brackets (13) on brushguard (12).
4.
Push hood latch (11) to left and hold, lift hood (9), and release hood latch (11).
5.
Remove hood (9) from vehicle.
6.
Remove eight screws (7), lockwashers (8), two reinforcements (14), and hinges (6) from hood (9).
Discard lockwashers (8).
INSTALLATION
NOTE
Assistant will help with steps 1 through 6.
1.
Install two hinges (6) and reinforcements (14) on hood (9) with eight new lockwashers (8) and
screws (7).
Finger-tighten screws (7).
2.
Position hood (9) on vehicle.
3.
Push hood latch (11) to left and hold, lower hood (9), and release hood latch (11).
4.
Secure two holddown latches (10) to brackets (13) on brushguard (12).
5.
Install two hinges (6) and reinforcements (15) on cowling (16) with eight new lockwashers (4) and
screws (5).
6.
Tighten screws (7).
7.
Position instrument cluster (2) on instrument panel (1), and turn four lockstuds (3) 1/4-turn to
right.
8.
Install glove compartment (TM 9-2320-361-20).
0196 00-2
TM 9-2320-386-24-1-1
0196 00
HOOD HINGES REPLACEMENT (Contd)


Back to Top