TM-9-2320-386-24-1-2

2-1/2-TON, 6X6, M44A3 SERIES TRUCKS (DIESEL)

TECHNICAL MANUAL; EXTENDED SERVICE PROGRAM (ESP); UNIT, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL; VOLUME 2 OF 2

MAY 2001

TM-9-2320-386-24-1-2 - Page 230 of 636

REMOVAL

NOTE

Perform steps 1 through 5 for in-vehicle maintenance.

1.

Remove spring (2) from brackets (1) and (3).

2.

Remove nut (16), washer (17), and bracket (3), with throttle control cable (5) and accelerator

cable (4) attached, from throttle lever (18).

3.

Remove two screws (7), washers (6), and bracket (8), with accelerator cable (4) and throttle control

cable (5) attached, from governor (15).

4.

Remove two nuts (10), lockwashers (9), and three leads 54A (12), 770-R (13), and GND (11) from

fuel shutoff solenoid (14). Discard lockwashers (9).

CAUTION

Cap or plug all hoses and openings immediately after

disconnecting or removal to prevent contamination to the fuel

system. Failure to do so may result in damage to equipment.

5.

Disconnect fuel inlet hose (21) from elbow (22).

6.

Remove fuel supply line (20) and O-ring (19) from governor (15). Discard O-ring (19).

.

WARNING

.

Diesel fuel is flammable. Do not perform this procedure near open

flame, sparks, or electricity. Injury or death to personnel may

result.

0326 00-2

TM 9-2320-386-24-1-2

0326 00

GOVERNOR REPLACEMENT (Contd)