TM-9-2320-387-10

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

OPERATOR’S MANUAL

OCTOBER 2001

CHANGE 1

TM-9-2320-387-10 - Page 264 of 277

1. Oil Can Points.

Lubricate all oil can points every

3,000 mi (4,827 km), or semi-

annually, whichever occurs first.

Use seasonal grade OE on hood

hinges, tailgate hinges, door hinges,

door handles, transfer case shift

linkage,

accelerator

linkage,

transmission shift linkage, heater

control shutoff valve lever and pin,

heater control knob, and tiedown

shackles and plunger. Lubricate

cargo shell door paddle lock, rear

wire handle lock, and cargo shell

door

latches

with

PL-S.

2. Winch Wire Rope.

WARNING

Wear leather gloves when

handling winch wire rope.

Do not handle wire rope with

bare hands. Broken wires

may cause injury.

NOTE

Front and rear winch lubri-

cation is identical.

After each use, clean and lubricate

winch wire rope with GWR. Clean

entire wire rope with wire brush.

Perform winch wire rope cleaning

and lubrication every 3,000 mi

(4,827

km)

or

semiannually,

whichever occurs first, when wire

rope is not used.

3. Pintle.

Every 3,000 mi (4,827 km), or

semiannually, whichever occurs

first, clean pintle with wire bush and

lubricate rear plate fitting with

seasonal grade OE.

4. Steering System.

CAUTION

Do not overlubricate tie rod ends

and upper and lower control arm

ball joints. One or two shots is

adequate. Excessive lubrication

will result in the boot rupturing.

Observe

the

boot

during

lubrication: a seeping condition

indicates adequate lubrication;

expansion of the boot indicates

over lubrication.

Lubricate front and rear propeller

shaft, steering column, U-joints, slip

yokes, tie rods, upper and lower

control arm ball joints, radius rods,

pitman arm, intermediate steering

shafts,

and

idler

arm

with

GAA/HDO every 3,000 mi (4,827

km), or semiannually, whichever

comes first. Insert enough grease in

each U-joint to purge air and

impurities of all four cross-bearings.

If one or more cross bearings do not

purge, then shake, rotate and/or hit

shaft with a rubber mallet to help

purge cross-bearings. Repair or

replace bearing if necessary, notify

your supervisor

NOTES

Change 1

G-15

TM 9-2320-387-10