TM 9-2329-387-24-l
12-23.
STARTABILITY
TESTS
I
This is a top level test for problems with an engine that doesn’t start, or starts
but immediately stops, or is very hard to start. If the engine starts but
doesn’t
run well after starting, try the STARTABILITY tests first.
FOR THE ENGINE TO START, ALL OF THE BASIC SYSTEMS SHOWN BELOW
MUST BE WORKING.
THESE STARTABILITY TESTS WILL HELP YOU TO
VERIFY THE CONDITION OF EACH OF THESE SYSTEMS.
BAlTERY
I
I
ClRCUrr
I
ENGINE MECHANICAL
(CRANKING, COMPRESSION,
ETC.)
I
I
ENGINE STARTED,
AVAILABLE
FOR POWER
I
. :
A functional flow schematic is not applicable to this section.
However, so that you may refer to sections as you need them, a
quick index to the systems required for starting is given here.
PARAGRAPH
I
PAGE
BAlTERY
ClRCUlT
2-237
GLOW PLUGS CIRCUIT
2-289
STARTER CIRCUIT
2-247
FUEL SYSTEM
2-99
AIR INTAKE/EXHAUST
I
2-141
COMPRESSION/MECHANICAL
1
2-147
2-45