TM-9-2320-387-24-2

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 2

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-2 - Page 538 of 1555

TM 9-2320-387-24-2

15-3. ENGINE MOUNT AND INSULATOR MAINTENANCE (Cont’d)

1.

2.

3.

4.

5.

6.

7.

install engine mount (2) and insulator (9) on engine (3) with three lockwashers (4) and

capsmews (5). Using 9/16-m torque adapter, tighten capscrews (5) to 30-40 lb-R (41-54 IV&.

using cmvfbot and adapter, tighten nut (11) to 24 lb-R (33 N*m) on starter support bracket (1) and

starter (10).

Lower engine (3) until insulator (9) is aligned and resting on engine mount bracket (6). Install two

washers (8) and locknuts (7) on insulator (9) and engine mount bracket (6). Using 3Wn. torque

adapter, tighten locknuts (7) to 90 lb-R (122 N-m).

Remove pm (12) from sling bracket (14) and engine hf%ing sling.

Remove two capscrews (13) and sling bracket (14) from left cylinder head (15).

Remove two capscrews (17) and engine lift sling f?om right cylinder head (16).

Install two radiator supports (19) on airlift brackets (21) with four capscrews (201, washers (221, and

locknuts (18). Tighten capscrews (20) to 37 lb-R (50 N=m).