TM-9-2320-387-24-2
TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 2
DECEMBER 1997
CHANGE 1
TM-9-2320-387-24-2 - Page 864 of 1555
WARNING
C-pillar partition is extremely heavy and must be supported
during removal and installation. Failure to do so may result in
serious injury to personnel or damage to equipment.
NOTE
• These procedures cover replacement of left side mounting hardware
for the C-pillar partition. Right side is basically the same.
• Note location of capscrews for installation.
1.
Remove four capscrews (2) and C-pillar gap bracket (3) from wheelwell (1).
2.
Remove two capscrews (12) and washers (11) securing C-pillar partition stop bracket (9) to vehicle
floor (10).
3.
Remove eight capscrews (7) securing two C-pillar parition isolator brackets (6) to vehicle
wheelwells (1).
4.
Remove shims (5) and C-pillar partition (4) from vehicle.
NOTE
Note locations of capscrews for installation.
1.
Remove locknut (8), capscrew (13), washer (14), and C-pillar partition stop bracket (9) from C-pillar
partition (4). Discard locknut (8).
b. Disassembly
a. Removal
TM 9-2320-387-24-2
25-24
Change 1
25-9. C-PILLAR PARTITION MAINTENANCE
This task covers:
a.
Removal
c.
Assembly
b.
Disassembly
d. Installation
b.1. Inspection
INITIAL SETUP:
Applicable Models
M1114
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Automotive maintenance and repair: field
maintenance, basic (Appendix B, Item 6)
Materials/Parts
Nine locknuts (Appendix G, Item 168)
Sealing compound (Appendix C, Item 72.1)
Manual References
TM 9-2320-387-24P
Equipment Condition
• Cargo shell door removed (para. 11-14).
• Passenger seats removed (para. 10-45).
• Rear A/C evaporator removed (para. 25-22).
• Cargo shells removed (para. 25-7).
General Safety Instructions
C-pillar partition is extremely heavy and must be
supported during removal and installation.
Maintenance Level
Direct support
Back to Top
