TM-9-2320-430-10
TRUCK, TRACTOR, 8X8, M983
TECHNICAL MANUAL; OPERATOR'S MANUAL
JUNE 2009
TM-9-2320-430-10 - Page 19 of 868
•
When inflating tires mounted on the vehicle, all personnel must
remain out of trajectory of the side ring and lock-ring as shown by the
areas indicated. Failure to follow proper procedures may result in
serious injury or death to personnel.
•
Cracked, broken, bent or otherwise damaged rim components shall
not be reworked, welded, brazed, or otherwise heated or damage or
personal injury or death may result.
•
No heat shall be applied to a multi-piece wheel or wheel component
or damage or injury or death may result.
•
Failure to place wheel/tire assembly in safety cage prior to initial
inflation could result in serious injury or death to personnel.
•
When a wheel/tire is in a restraining device, do not rest or lean any
part of body or equipment on or against the restraining device, or
injury or death could result.
•
While changing tires or while performing tire maintenance, stay out
of the trajectory path. Failure to comply may result in injury or death
to personnel.
•
Always use an inflation hose with an in-line gauge and a clip-on chuck
when inflating tires. The gauge and valve must be mounted a
minimum of 10 feet (3.10 m) away from air chuck.
•
High air pressure may be released from valve stem when valve core
is removed. Stay clear of valve stem after core is removed. Ensure
all personnel wear suitable eye protection. Failure to comply may
result in injury to personnel.
•
Tire is heavy. Brace tire to ensure tire will not fall over on you or on
others.
WARNING
VEHICLE OPERATION
•
Speed limits posted on curves reflect speeds that are considered safe
for automobiles. Heavy trucks with a high center of gravity can roll
over at these speed limits. Use caution and reduce your speed below
the posted limit before entering a curve. Failure to comply may result
in vehicle crash and injury to personnel.
TM 9-2320-430-10
q
Back to Top
