INSTALL LIMP HOME SETUP/DRIVER SIDE FRONT - Continued
•
Vehicle must not be driven faster than 10 mph (16 km/h) or farther
then 30 miles (48 km) in limp home condition.
NOTE
•
Use limp home procedure for emergency only in case of wheel
bearing failure, wheel damage, or when unable to change wheel and
tire.
•
Limp home setup No. 1 axle is shown. Setup for No. 2 axle is done
in same manner.
•
For limp home setup on other axles, refer to passenger side front or
any rear wheel section above.
1.
Remove two wheel chocks (1), jack base plate (2), jack (3), and 7 ft. (2.1 m) chain (4)
from stowage.