TM-9-2320-431-10-1
TRUCK, WRECKER, 8X8, M984A1
TECHNICAL MANUAL; OPERATOR'S MANUAL; PART 1 OF 2
JUNE 2009
TM-9-2320-431-10-1 - Page 1099 of 1244
INSTALL POWER PLANT - Continued
CAUTION
•
Refer to applicable technical manual to prepare vehicle for power
plant installation to prevent equipment damage.
•
Do not allow power plant to swing and come in contact with vehicle.
Power plant or vehicle may be damaged.
NOTE
•
Retrieval system may be lowered to assist in getting closer to vehicle.
•
Position wrecker for best access to install power plant.
10.
Position rear of wrecker (7) in line with vehicle.
11.
Operate HOIST control lever (4), and raise power plant high enough to clear vehicle
for installation.
12.
Drive wrecker slowly backward as close to vehicle without making contact to position
power plant for installation.
13.
Operate HOIST control lever (4), and SWING control lever (8) to position power plant
for installation.
14.
Setup outriggers. (WP 0106)
15.
Install power plant (1) (refer to applicable vehicle technical manual). (Table 1)
16.
Remove sling (2) from power plant (1).
17.
Remove sling (2) from load hook (3).
18.
Shut off switches, disconnect remote-control unit, (WP 0106) and return remote-
control unit to wrecker stowage.
19.
Shut down crane and stow outriggers. (WP 0106)
END OF TASK
END OF WORK PACKAGE
TM 9-2320-431-10-1
0111
0111-11
Back to Top
