TM-9-2320-431-10-1
TRUCK, WRECKER, 8X8, M984A1
TECHNICAL MANUAL; OPERATOR'S MANUAL; PART 1 OF 2
JUNE 2009
TM-9-2320-431-10-1 - Page 286 of 1244
PAYOUT CABLE AND CONNECT TO MIRED VEHICLE - Continued
Table 1.
Heavy-Duty Winch Pull Capacity.
Winch Type
Cable Layer
Cable on Drum
Capacity
60,000 lbs
1
0-48 ft. (0-14.64 m)
60,000 lbs (27 240
kg)
2
49-105 (14.95-32.03
m)
49,780 lbs (22 600
kg)
3
106-172
(32.33-52.46 m)
42,545 lbs (19 315
kg)
4
173-250
(52.77-76.25 m)
37,140 lbs (16 862
kg)
9.
Make sure weight of mired vehicle and amount of winch cable left on winch does not
go over pull capacity (refer to FM 4-30.31 (Volume 2, WP 0200) and Heavy-Duty
Winch Pull Capacity table above).
10.
If 60-ton tackle block must be used for recovery, attach 60-ton tackle block to disabled
vehicle and winch cable. (WP 0109)Remove snatch block from winch cable
(WP 0116) and tree, another vehicle, or heavy object (refer to FM 4-30.31). (Volume 2,
WP 0200)
11.
Connect end of winch cable to rear tow eye of wrecker, another vehicle, or other heavy
object. (Volume 2, WP 0200)
12.
Connect winch cable to mired vehicle.
RECOVER MIRED VEHICLE
NOTE
•
If using remote-control unit, skip to Step (2).
•
If using vehicle mounted (manual) controls, continue with Step (1).
1.
VEHICLE MOUNTED (MANUAL) CONTROLS:
a.
Set POWER switch (1) to ON (LOW IDLE ONLY).
TM 9-2320-431-10-1
0043
0043-10
Back to Top
